pawl
英
美
网络 棘爪; 制转杆; 掣爪; 卡爪
复数：pawls
英英释义
noun
- a hinged catch that fits into a notch of a ratchet to move a wheel forward or prevent it from moving backward
双语例句
- The feasibility for rolling special section pawl steel with the existing& 180 mm mill at laboratory has been discussed.
研究了用180mm轧机轧制异型断面棘爪钢的可行性。 - A bracket will be installed within the transmissions to assure that the park pawl shaft remains properly in position.
在变速器内安装保持架来确保驻车止动爪定位销处在正常位置。 - The fine blanking dies of the pawl and the chute used for the seat recliner were firstly introduced in this thesis, and failure analysis has been carried out in view of mechanical calculation, metallographic test, hardness test and SEM.
本文首先针对棘爪、滑槽板两副精冲模具出现断裂的凸模，从力学强度校核、金相试验、硬度试验、断口电镜扫描等进行试验分析。 - Heavy hammer on the pawl through the release of the lock device on Spindle lock spindles;
重锤上的棘爪通过释放装置上的锁锭轴锁锭； - This paper introduces the structure and design characteristics of pawl pole permanent synchronous machine, and illustrates the relations among main structure sizes.
介绍爪极永磁同步电机转子的结构及设计特点，并说明了一些主要结构尺寸间的关系。 - The virtual prototype of the clutch is built based on Pro/ E and the switch process of the SSS clutch is simulated by MSC Adams. The simulation of the impact performance of the pawl and pawl wheel and the engaging performance of the middle part is finished.
利用Pro/E及MSCADAMS建立该离合器的虚拟样机模型，并在MSCADAMS中对离合器动态接合过程进行仿真，分析棘轮棘爪的碰撞特性，以及中间件的啮合特性。 - If the cup plug is missing, the park pawl anchor shaft can move out of position under certain conditions.
如果该杯状固定塞脱落，驻车止动爪定位销可能在特定情况下滑移出正常位置。 - Analyzing the reasons of spring failure on pressing pawl of cutting machine and heat treatment
剪板机压料爪子弹簧失效原因分析及处理 - The blades are positioned on the large handle by a rotating shaft screw, and the pushing pawl and a pawl torsion spring are connected with the small handle through the pawl pin.
小手柄上通过棘爪销柱连接有推进棘爪及棘爪扭簧，推进棘爪受到棘爪扭簧的压力始终压制在刀片的齿上； - Ratchet mechanism is often used in the reducer of the casting crane. This paper uses Pro/ ENGINEER software to create the ratchet mechanism and simulate its running and studies the stress and deformation of the ratchet wheel pawl by Pro/ MECHANICA.
针对铸造起重机用减速器常采用的棘轮装置，采用三维实体造型软件Pro/ENGINEER建立其实体模进行运动仿真，利用Pro/MECHANICA有限元分析模块对棘爪进行应力、应变分析，得到棘爪需加强的部分。