deflections

英 [dɪˈflɛkʃənz]

美

n.  (尤指击中某物后)突然转向，偏斜，偏离
deflection的复数

柯林斯词典

• N-VAR 偏斜;偏转
  Thedeflectionof something means making it change direction.
  1. ...the deflection of light as it passes through the slits in the grating.
     光线通过光栅狭缝时的偏转
• (体育运动中球击中某物后的)转向，变向
  In sport, thedeflectionof a ball, kick, or shot is when the ball hits an object and then travels in a different direction.

双语例句

• They observed the deflections of the particles by allowing them to fall on a fluorescent screen.
  他们让粒子落在荧光屏上以观察他们的偏移。
• Experimental results indicate that the cracks weaken the strength of slabs, lower their stiffness, and induce the deflections of slabs beyond limit.
  试验结果表明，支座边的裂缝严重削弱了板的承载力，降低了楼板的刚度，导致楼板的挠度过大。
• Vertical elements carry sufficient load through cantilever action to produce cantilever deflections equal to arch deflections.
  垂直杆件则借悬臂作用产生和拱挠度相等的悬臂挠度，来承担足够的荷载。
• In geometric nonlinearity, the effects of instability produced by axial forces, the bowing of the deformed members, and finite deflections have all been included.
  在几何非线性的影响下，所产生不稳定的轴向力、弯曲变形产生的弯矩，以及有限制的偏移量均包括在内。
• However, while some building codes provide methods for estimating shear wall deflections, these methods are not adequate for shear walls without hold-downs.
  尽管有些国家的建筑规范中已给出了估算木结构剪力墙侧向变形的方法，但这些方法并不适用于无抗倾覆锚固件木结构剪力墙。
• The deflections of throttle slices were analyzed and the equivalent relations of flux distribution were deduced according to the structure of self-designed hydro-pneumatic spring.
  根据自主研发阻尼可调油气弹簧的结构形式，分析了叠加节流阀片的挠曲变形量，给出系统流量分配的等效关系。
• Where required, to examine deflections, stiffness requirements, and any special material and design provisions to obviate brittle fracture under adverse conditions.
  必要时验算挠度、刚度要求、以及任一特殊材料和设计规定，以预防不利条件下的脆断。
• An increase in resistance to roll deflections may be gained by splitting the single strut into a fork at the top.
  采用上部分呈叉状的单支杆可以增强抗滚转变形性能。
• Unsteady Transonic Flow Computation for a Wing with Control Surface Deflections by Euler Equations
  跨声速机翼操纵面非定常气动力Euler方程计算
• But, more significantly, the overturning moment and the shear deflections produced by lateral forces are much larger and must be carefully provided for.
  更重要的是侧向里所产生的倾覆力矩和剪力变形要大的多，必要谨慎设计来保证。